Raspberry Pi Mount for Black Case

Needed to wall mount an older Raspberry Pi 2B that came with this black case.

I think some of Rpi 3s came with case as well.

Has two channels built in where a zip tie can feed through and secure the Case to the mounting plate.

x2 Holes are sized for #6 Machine Screws

The arrow points to where the SD card slot should be when attaching the case to this mount.

Need to use good zip ties. The channels are tight, so cheaper zip ties may not fit

EDIT - Added a stubby version too. Just a smaller version that would probably print x2 faster.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

.2

Infill:

15%

Filament: PLA PLA

Notes:

Put cuts in the bottom of this model just to make it get done with first layer faster. I print my first layer @ 1/2 to 3/4 times the normal speed usually.

The arrow points to where the SD card slot should be when attaching the case to this mount.

Category: DIY