Shutdown Button

Please keep all these small parts away from children and pets, some parts have pointy ends, and they could be a choking hazard too.  Make or use these models at your own risk.

This is a 2 part “Shutdown” button.  It was designed for a 0.4mm nozzle and I suggest using a layer height of 0.1mm, but it should look OK with larger layers.  I printed it so the outside face was printed down, which will give it a shiny look if the bed is smooth.

There is about 0.17mm of gap to allow the inserts to fit, so they should be glued in place (Gorilla SuperGlue Gel works well on PLA).  The inserts have a bevel at the bottom to help with getting them installed, but you may still need to clean up any elephant foot on the inserts prior to installing (or they may not fit the tight pockets they go into).

This will be entered in the Clothes Buttons Contest so please like if you like it, and good luck to everyone one participating!

If you print one, please post a make.  The STEP file is included for easy remix'n.

If you like this thing, please like it or download it (which helps to get me closer to my first free spool of Prusament).  Or you can check out my site, to see what other projects are in the works.

Designed using ViaCAD3D Pro V12