A wall-mountable case for the Raspberry Pi Touch Display 2 and a Raspberry Pi:
The thick version is 60mm thick, allowing room for any Pi HATs, but the thin version is 35mm thick, and comfortably fits a Pi and the display.
On my printer (Creality K1C), it prints fine in the flat orientation without any supports, although supports may be preferred for large cable holes. It may be preferable to use a larger infill for the thick case to make sure the screw standoffs are stronger.
The M2.5 screws included with the Pi Touch Display 2 can be used to attach the Touch Display 2 to the case. It is also possible to use some double-sided tape around the screen bezel to make the assembly stronger.
You may need to use right-angled cables/adapters for some of the ports, especially the power/HDMI/audio ports.
The author marked this model as their own original creation.