Parametric protective case / toolbox

Parametric protective case/toolbox with a groove for an optional seal. 

You can modify width, length, height, corner radius, screw hole size, hinge position, rib and box thickness.

Print settings

• any rigid filament
• 0.2mm layer height
• 0.4mm nozzle
• no supports needed
• default infill
• colored icon → emboss .svg icon in slicer (to same height as 1st layer) and manually swap color on 2nd layer

Assembly

You will need 6x30mm M3 screws. The tolerances should be just right by default, if not, heat or lubricate the screws a little. I recommend screwing them from the outer edge. For the seal, you can use a soft, 1.75mm TPU filament.

For icons I used, look here:

https://www.onlinewebfonts.com/icon/547002

https://www.svgrepo.com/svg/47967/pc-tower-and-monitor

https://www.flaticon.com/free-icon/repair-tools_82525

https://www.svgrepo.com/svg/159891/circuit

If you want a handle for the box, have a look here:

https://www.printables.com/model/84450-parametric-folding-handle

https://www.printables.com/model/75806-tool-box-handle-for-tool-box-parametric

Fixed and reduced the fillet on the bottom part of box body