Raspberry Pi 5 + Pimoroni NVME Case with official fan mount

Note!
If you don't have the Pi 5 official case, then you probably don't need or want this remix. Just buy the official Pi 5 cooler instead and use the original model.

Print instructions:
The top is printed with the top facing down, you might need some small tree supports for the fan-clips. But might print fine without them too.

The bottom prints normally with the bottom facing down, no supports.

Assembly is the same as the original model.

This small remix moves and changes the fan mount to use the fan from the original Raspberry Pi 5 case. I've also added more ventilation holes on the bottom for the NVME drive.