Great case! Fit my Pi 5 with Waveshare PoE hat (not the m.2 version, just PoE) perfectly. Assembled fine with the included M2.5 bolts, no additional hardware needed.
Raspberry Pi 4 & 5 PoE Case
Case that fits the Pi 4B with PoE Hat, also has optional mounts to attatch to a wall or wherever. (Pi5 experimental)
32
317
4
1842
updated December 4, 2024
Makes
Comments
Nice easy print, fits my 4B neatly and blends into the rest of the server rack 👍
On all the cases, I can see that there is really only one layer for the screws to eat into, could we add a bit more meat (more layers) between the screw head hole and the screw thread hole? I'm specifically printing for the Pi 5, and i have M2.5x8mm screws, so I could use like 2mm of thickness .
Any chance of a remix for Pi5 (the usb ports/network plug are swapped), and the hat sits higher up
View 2 more comments
@Slaur_4819 that PoE hat is ~0.5-1.0mm wider than the opening in the lid. It's too tight to force it on.
@Slaur_4819 Sorry for not responding sooner - been stuck working 80 hour weeks at work. I did end up with the waveshare poe hat without m.2, so I'll give this a try. Appreciate it!
It fits the Raspberry Pi 4B with PeE+ hat very well, but why are the holes in the top not aligned with the fan? As a result, the processor temperature has increased, I had to remove the top for it to cool down a bit... I would have preferred a case that leaves a bit more room inside for air to circulate, even if that means a bigger case.
View one more comment
@Slaur_4819 I added a model where i moved the fan holes so that they should fit the PoE+ model better, this is measured from the product brief PDF.
@Slaur_4819 Thanks a lot 🙂
Great fit with the Raspberry Pi 4 and PoE+ hat. The stringing is my poor printing setup and not the model's fault.
I used the same screws that came with the RP PoE+ hat on a RP 4B and the bottom fits really well. I think the top ones needed longer screws and suspect I may have broken the recessed screw holes. Nonetheless the top part was very secure and I didn't feel the need to reprint/redo it.
Finally a case that fits!
I have a 52Pi PoE adapter (EP-0127), which has a slightly offset 30x30mm fan.
Great design - prints well