Hi, Are there different types of X-max 3 printers and yours if physically different than the original model? Or did you improve the model to tighten up the tolerances? I have the x-max 3, and I'd like to have this little tray.
@BryZarr_248380 Qidi changed the design shortly before the market release, they even postponed the release following the review of @Clough42 ( https://youtu.be/hg7m0t-4h5s) Since I pre-ordered the printer, I assume I have the original version and @Getfar_1603461 an updated one.
The only change I did is the one I marked on the last image, to accommodate the frame reinforcement. If the frame looks different in your printer, you probably want the original model by Getfar. (edited)
Printed great in Polymaker Jet Black ASA. Scanning is so much faster than probing, a 25x25 mesh at 300mm/s takes probably a quarter of the time it took the stock inductive probe to do a 9x9 mesh. Not having to set the Z offset anymore is nice, too (edited)
Would you care to share your config files? Did you find them or are they on github?
I cant seem to find a good config. So far I have installed the eddy and checked for communication through Putty but cant seem to get the BTT config to work.
View one more comment
@c8_h10_n4_o2_850319 I found that my klipper needed to be updated through putty. I went the FreeDi then the BTT sample route. Now its all in mainline klipper so its redundant. Thank you for your response!
@MrD_1674479 hey there! I also went the freedi route, can you explain exactly what you did to get this to work? I'm about to receive mine and wanted to make sure i do stuff correctly ! Cheers
Printed in Black ABS. I knew I needed a funnel after spilling a heap of beads all over my desk. This works perfectly and prints nicely. It also almost works with my desiccant product bottle for putting beads back in.
