I really liked this design, but it tips over pretty easy with the lid in place.
Update : I failed to mount it to the top of the printer as shown in the pictures, thus the issue I was having with it unsecured. (edited)
@Firestonevik_1860681 I used sticky glue strips to hold it to the top of the printer and haven't had any issues.
Or are you experiencing a different issue and I am misunderstanding?
@TatersTots_731616
I feel dumb. I did not think to mount it to the top of the printer like that and had been using it loose on a table next to the printer (thus the overturn issue). It fits the lid great and I really like the look of it. I will mount it today. Thanks again for the model
Works ok, requires a bit of double sided tape to stay onto your printer. Thanks for sharing!
Can you send a Picture where is finish in Printer? I dont understand to montage this...
