I wanted to switch from an older itx case that was a pain to do maintenance with. I tried this 3d printed case, I am overall impressed but I have some mentions for those who want to try to use this case: - check if the rods are actually 12 mm, mine were 12.15 and were a pain to insert. - the radiator mounts did not fit in any way.I was lucky and found a way to use them with my specific fans, but is something that I intend to change later. - I was tempted to use the case without panels, but I realized that only friction is holding everything vertically without the panels. I modded the original panels and printed the front and back ones to make sure the rods cannot slip.
Mine is obviously still I work in progress but I like this case a lot.
I wanted to switch from an older itx case that was a pain to do maintenance with.
I tried this 3d printed case, I am overall impressed but I have some mentions for those who want to try to use this case:
- check if the rods are actually 12 mm, mine were 12.15 and were a pain to insert.
- the radiator mounts did not fit in any way.I was lucky and found a way to use them with my specific fans, but is something that I intend to change later.
- I was tempted to use the case without panels, but I realized that only friction is holding everything vertically without the panels. I modded the original panels and printed the front and back ones to make sure the rods cannot slip.
Mine is obviously still I work in progress but I like this case a lot.