Raspberry Pi 4B Case - Configurable

About

This is a Raspberry Pi 4B case that has a few configurations for different scenarios. The two parts of the case snap together and can be release by pushing in the front sides and lifting up. This case was designed in OnShape.

Requirements

• 4x M2.5 Bolts 4x M2.5 Nuts
• Raspberry Pi 4B 40mm
• fan and standard screws (optional)

Configurations

There are 2 different bottom halves, one for mounting a bolt going downwards from pi to base and one for mounting the other way round. This is helpful if like me you have a heat sink / HAT that requires the bolts to come from below There are 4 different bottom halves, one which supports a standard 40mm fan and another that is fan-less, the other 2 are the same but also have slots for the DSI cables.

Assembly

1. Before starting, remove the SD card from the pi.
2. Line up the side IO cover with the IO on the pi and insert
3. Then insert the pi into the bottom half of the case ensuring that the IO cover slots into place.
4. Add bolts and nuts where necessary to hold the pi into the case.
5. If using HATs or DSI cables attach them now. If using a fan attach it to the top half of the case and plug the power pins in.
6. Line up the back clip of the top half with the slot in the bottom half and insert.
7. Apply some pressure downwards to the front and push inwards the sides on the marked points, the top piece should clip into place.
8. To remove the top piece, push inwards on marked parts on the sides of the top piece and pull upwards.

Credits

Credit to @print_byte for the ‘Raspberry Pi 4 B’ model used in renders and also used as reference when designing the case. Link: https://www.printables.com/model/727545-raspberry-pi-4-b