Created this holder for the Filament Swatches by makkuro to reuse them to see which filament is in loaded in which entry.
In the MMU2S from Prusa you can load up to 5 filaments, so its hard to remember which is where, so I reused the already existing Filament Swatches from makkuro and added them on the outside of my door to the printer.
I uploaded versions with the numbers 1-5 for the different entries in the MMU2S and a blank one.
There is enough space that's its easy to remove it again.
Print it “standing” (like its done on the picture), than no support is needed (needs to be flipped 90 degrees).
no supports
no rafts
0.2 mm resolution, but also 0.3 should work
PLA worked, others should also work
The author remixed this model.