XBOX 360 controller + headset holder with cable routing

Why I made this

I made this controller + headset holder for a friend (that's why I don't have a picture). he wanted something like the holder from "3l3m3nt"(I can't find him at thingiverse anymore. he probably deleted that design). But the cable was just hanging down and I was a litle bit anxious that it will kink off and break. So I made a cable routing thingi to it.

How to print it

I printed it on my Ender 5+ with standard Black PLA (by Janbex)but it should print on other printers and other filamentbrands just the same. I used supports for the upper clip and for the screw holes. 

You probably won't need the support for the screw holes. I just wanted to be on the safe side…

I printed it with a 0.4 Nozzle and 0.2 Layerhight and used 30% infill.

…my standard settings for simple prints.

How to mount it

this holder has 3 Screw holes that can be used to screw it onto a wall.

you could probably also use double-sided tape to stick it to your wall. 

But pleas be careful, this could damage your wall.

Function

The controller snaps into the mount and thanks to the cable routing it does't kink off.

The headset can hang down from the bracked underneath the controller.