Scrub Daddy Sponge Holder v2 with CADDY

This is a mashup of what I feel are the two best scrub daddy holder designs for a divided sink. 

NOTE: THE SEPARATE FACE PIECES ARE THE EXACT SAME AS THE ONES FROM THE SCRUB DADDY V2 SPONGE HOLDER.

Thank you to the original creators of both of them and I hope you like this version!

PRINTING: For print settings on the caddy, I haven't fiddled with position on this much but I usually prefer a 45 degree angle to keep from there being too many supports in places, making it ugly.

For the face pieces, they don't need supports, just print them facing upward.

The original Scrub Caddy had two baskets (one on each side) in addition to the sponge holder on one of the basket sides… but the whole thing didn't fit right over the divider we had AND it just took up/had too much space to hold stuff. 

Meanwhile, the Scrub Daddy Sponge Holder V2 by MKCAMC was PERFECT over the divider, holding tight, but it didn't have any place to hold our steel scrubber and looked one-sided. Hence, the perfect design… a mashup of them both!