Angled Husky Label Clip

I printed these in ABS with a 0.8 extrusion width. I recommend increasing your “minimum print speed” settings in filament cooling parameters to enable these to print a bit faster (albeit at the expense of some quality). I think I found a good middle ground printing at a minimum of 40 mm/s, 0.28mm layer, 0.8mm width. 

edit: oh gosh, minimum of 40 mm/s, not four hundred like I originally typed… 

• Added a little lip for aligning a stick-on label
• The lip is positioned so that 24mm label tape will be centered
• The clip is 90 mm now. Why?
  • I wanted to print this in vase mode but get multiple objects on a tray
  • On my BambuLabs X1C, ~90mm is the cutoff where the “print by object” will still pass
  • You can print 3 per tray with this setting