Modular socket holder for 3/8 and 1/4 drives

similar design to popular socket holders. I suggest printing the pegs in a brighter color of filament than the base.  I painted mine but plan to reprint dual color soon

I used 15% infill, 3 outer layers printed at .2 height on a prusa mini with PLA and superglued 10mmx2mm magnets into the bottom.  

I suggest printing the spacers without a brim if you can, something about printing these with a brim made the tolerances really tight. 

If I were to remake these i would go with a larger magnet like a 15mmx3mm  just for some more holding power, but the 10x2 work fine as long as you don't have too thick of a mat under them 

sized down 3/8 and 1/4 drive from original to be shorter and narrower. takes up less room in toolbox