Also fit's Ender 3 V2 Neo perfectly
CR-10 Rotating Filament Sensor
DONATE:https://paypal.me/JuanCMedina21?locale.x=en_US I made a rotating filament sensor for the top of my CR-10 MAX.…
29
232
5
1390
updated December 18, 2021
Makes
Comments
Printed and mounted on my Ender 3; still need to wire it up. Had to extend the mount to reach over the light bar, but otherwise, a solid design. Printed in Polymaker Red PETG at 0.16mm layer height with gyroid infill for extra strength.
Works Great. Well thought-out design
Modelo muy simple y precisamente por eso, absolutamente genial. Con un simple rodamiento consigues que el filamento vaya siempre lo más recto posible y sin fricción.
Es muy fácil de imprimir PLA con 25% de relleno, se imprime perfectamente sin soportes y sin expansión horizontal si tienes bien ajustada la máquina.
Es una impresión rápida e ingeniosa. Mi más sincera enhorabuena y mi gratitud al autor.
@Comicrocket_307636 Did you use heat-set threaded inserts with the stock mounting bolts or are they just threaded into the plastic?
@NevarroGuildsman i threaded into the plastic
Pas encore imprimé
One of the best functional prints for my direct drive and I see on a cr10 Max.
Also could you elaborate how you put your PTF tube through the aluminum block.
@Narco74_126558 you drill it to the size of the PTF tube, i can't remember what size drill bit I used. It's aluminum, so it's easy to drill.
@youngjc_192756 that's what I thought. Thank you for the quick response.
Macht was es soll