I totally liked the stand from Helmchen, buuuut i wanted it to print a bit faster (around 3h 40mins for the biggest @0.2mm layer height and 60mm/s speed),print without support, and "waste" less material.
So the biggest stand of me uses 25g of filament (top and podium), while the original takes around 46g. And is printable in 2h 40min @0.2 layer height and 60mm/s (while the original runs for 3h 10mins.
Well yes, thats not a real benefit... also mine have to be glued together, when finished.
Ive reused nothing and built them by scratch, but obviously with the design of Helmchen in mind. So its a remix and all cheers and beers should go to his adress!
Printer: Tevo Tornado
Rafts: No
Supports: No
Resolution: 0.2
Infill: 5
Here you see how i put the original file from Helmchen_fire into Tinkercad, and rebuilt the walls after that.
The author marked this model as their own original creation. Imported from Thingiverse.