Locking Twist On Connector - Magnet Key

Remix for your own needs- STEP files included.

Requires glue and 5mm x 3mm magnets (x4) for assembly.

No supports needed for raw parts (see pic for suggested orientation); at least 2mm layer height recommended; at least 4 wall perimeters.

1. Glue magnets in the wedge key and outer connector. Check their orientation to make sure key magnetically locks in place.

2. Once the key is in place, glue handle to the back of the key to block it from falling out. It is intentionally big for my use- change it for your needs.