Stealthburner Microprobe Mount

Pretty simple little mount to put a BIQU Microprobe on a “stock” Stealthburner carriage mount. Goes in the same spot as the stock induction probe, and is adjustable about 10mm down to suit different hotend setups.

Only tested on my Siboor Switchwire (Enderwire), please give feedback for your printer.

BOM:
2x M3x4x5 heatsets
2x M2.5x3x3 heatsets
2x M2.5x4 screws

This uses the same M3 screws from the induction sensor to mount.

There is an optional version without the M2.5 heatsets, use M3x4 threaded into plastic instead. (I have not tested this version, please give feedback!)

Offsets:
X: 2
Y:  21

Like my work? Please consider supporting me on Ko-fi!

LINKTREE