Sig P938 single stack 9mm Speed Loader

I couldn't find a single stack 9mm speed loader I liked that was compatible with my Sig P938 so I modeled one that I did like. I printed it using fuzzy skin for more grip and a nice look. I used PLA with 50% cubic infill and it seems more than strong enough. If you are going to keep it in a range bag that may see a lot of heat, get left in a car, etc., you may want to use PETG or another heat resistant filament.

I printed this with the base loaded onto the print bed and used organic supports for the pusher that would end up free-floating in air if not supported. Picture included.

Since I am not concerned with perfect esthetics, I printed mine with .6mm nozzle and .3mm layer height. I find these settings to be strong and functional, but not as cosmetically pleasing as a smaller nozzle and reduced layer height. My print time was 1 hour and 49 minutes and used approx. 13.6 meters of 1.75mm filament.