Its a really cool case, but I hate the fact that cables attach at the top. So I'll probaby try and find another model to print :)
Fractal Baby North - Raspberry pi case (3, 4 & 5) + BIGTREETECH Pi 2 (beta)
Makes
Comments
Great case with sensible changes to the original. Printed quite easy and looks great. Thanks for the model!
Would M2.5 x 4 (total OD) x 4 (L) inserts work? You mention M2.5 x 3 x 4, but it seems most vendors advertise the second number as OD which means the latter would just fall through the hole. If you mean 4mm as the OD then wouldn't 3mm length be too short for the 5mm deep holes?
Some parts are a tight fit, so you have to file down some connection points. Overall, the model is good.
Came out really nice, main body took a few tries on my M5C… Just waiting on hardware.
@GrantMaier_2311884 Hi, Lovely print, Any chance you could send me a link for the side panel? Thanks in advance!
@EmileSela_960681 Can't seem to find it now, someone had published it... I believe this is the original creator of it: https://www.reddit.com/r/raspberry_pi/comments/1f54dzy/yet_another_fractal_north_pi_case/
Did someone try making the baby north a bit wider to make room for a 2.5" SSD. I would love to, but i dont have access to a 3D printer, so prototyping would be really expensive and tedious with a service to print it for me.
So i was hoping someone wanted to do the same as well and might want to share their remix.
Nice, thanks! I used also 3mm inserts, didnt simply have any 2,5mm and holes were a bit large for 2mm hardware.
