Lego saturn 5 low profile wall mount

Check out my custom 3D printed wall mount for the LEGO Saturn V (LEGO Ideas 21309). Printed in black PLA, this easy-to-install mount holds your rocket securely on the wall, turning it into an awesome display piece. Perfect for any LEGO fan looking to save space and show off their creation. To install, you’ll need three screws with a diameter of 3.5mm and a minimum length of 30mm, plus one cable tie. You will need to drill holes into the wall, as displayed in the following picture:

(The holes are not to scale)

The cable tie is installed by removing the third stage and wrapping it around the single J-2 engine, you also need to remove some of the outer casing of the rocket.

This is the piece you will need to remove:

In the end, it should appear as follows: