Buffer Tube stock for Worker Folding Buffer

Here's a simple stock for my folding Worker buffer. I took the dimensions directly from the part so I'm not sure if this will work for a real steel application. The holes in the stock are ½ inch so you can stuff half darts in. 

It uses one M8 nut and washer and one M8x20 button head socket cap machine screw. I'm sure other types of heads will work fine. There's a hexagon to drop the nut into then the screw and washer go in from the outside. I did end up filing off just a hair off of the end of the machine screw to make it fit better but I doubt it was necessary. 

Lay the butt flat on the bed and then it should be fine without supports or raft but I don't think those would hurt if your printer usually needs them. I also added walls but kept the infill low but also I'm not sure if you need that. 

Also I added a split model so you can make sure your scale and hardware are fine  :)