Raspberry Pi 5 Case with Pineberry HatDrive! Bottom

Case for Raspberry 5 with Pineberry Pi HatDrive! Bottom NMVE SSD expansion board.

The case has alternate retention mechanism and a slide out cover to allow access to the SSD without removing the case.

Details

Parts to Print

• x1 Case Bottom with threaded insert or Case Bottom with 3D printed threads.
x1 Case Lid. x1 M.2 cover. x4 foot x1 M.2 retention clip if you want to swap SSDs

Required Materials

• x1 Raspberry Pi 5
x1 Pineberry Pi [HatDrive! Bottom](https://pineberrypi.com/products/hatdrive-bottom-2230-2242-2280-for-rpi5) x4 M2.5 10 or 12 mm screws to attach feet to bottom and to board. x2 M2.5 8 or 10 mm screws for lid rear. x2 M2.5 4 or 8 mm screws for lid front (screws that come with board will work). x4 M2.5 threaded [inserts for 3D printing](https://www.amazon.co.uk/SHEENO-Knurled-Threaded-Bushings-Internal/dp/B09B6WRJ7F) if using threaded insert version of case bottom.

I hope to improve this case in the future with support for HATs and better access to GPIO pins and camera connectors.