This a modified poop emoji to include a 1x2 lego brick opening in the bottom and the eyes are set up to house a lego stud each (they are not spaced for a 1x2).
My printer prints everything a hair small so the dimensions of the "eyes" stud holes and the brick bottom are slightly larger than a normal lego allowing me to print without scaling up. If you print yours and it doesn't have a good snug fit, just size down or up slightly in your slicer depending on your issue. This is the final design of this particular model for me.
Printer:
Anycubic Kobra Neo
Rafts:
Doesn't Matter
Supports:
No
Resolution:
150
Infill:
20%
Filament: any PLA (+) any
Notes:
I printed mine at 20% infill but the reality is this is a trinket. It can be a smaller percentage. I did print with a wall width of 1.2mm (3 walls thick) but .08 is probably fine too.
Category: 3D Printing
The author marked this model as their own original creation. Imported from Thingiverse.