Gridfinity Jumper Wire Storage Divider Bins

Storing jumper wires in bins (rather than on combs) allows for fast access when wiring a prototype.

These bins have been optimized for a thinner bottom / more storage space. 

The height is 4 units (4 x 7 = 28mm), allowing me to stack the 2 trays in a single drawer height.

The size is 3x3, which is suited for 10cm jumper wires.

Wonder why I have so many more red, black, yellow and blue compared to other colors? Because I use so many more of those colors: Red for Vcc, Black for GND, Yellow for i2c SCL and Blue for i2c SDA ;)

If you need another size, please post a comment.

• Flat bottom
• Thinner bottom in order to maximize storage space and reduce infill waste
• Removed magnet holes for faster printing