This worked great!! Thanks for posting. The fit is perfect for every setup block and each can easily be plucked from the holder! PLA Matte 0.24mm draft mode, 3 walls, 15% gyroid
Gridfinity Router Table Setup Block Holder
A 4x4x5 Gridfinity holder for my Neitra router table setup blocks.
11
33
2
463
updated December 9, 2024
Makes
Comments
Printed nicely, but the smaller setup block sizes are too small. I didn't change any settings in my slicer (Bambu Studio) before printing (layer height 0.2mm, 2 walls/wall loops, 15% infill), using a 0.4mm nozzle. I'd rather not have to sand the holder, and will probably print it again. Any thoughts on settings that might make it a little more loose? Also, I've got the exact same set of setup blocks as you do. (edited)
View 3 more comments
@zrlevin_300275 That's fantastic! Thank you so very much! I still kind of want to mess with the original to see if I can figure out if my setting choices can help, but I will definitely print the updated one for now to store my blocks 🥰
@Shadoweclipse_617082 I just printed the 0.4in tolerance holder and it is PERFECT. No settings changed for that. Thank you again!!