Vertical Hydrometer Mount

This version will fit the same hydrometer as the original model, below is a link to the ones I used. This model will hang vertically from the lid and show on the side of the container instead of at the top of the lid. Since I was storing mine on a shelf above my printer I was unable to see the sensor read out on the lid.

Print in PLA or anything you like, I suggest organic supports on the lip of the clasp and the squares on the holder. This will make sure they are the correct size and the organic supports are easier to remove. I printed mine with 0.2mm quality setting but another setting should work fine. 

https://amzn.to/3VKiqYK

This version is ina vertical position instead of horizontal to the lid.