This model will support the NI Maschine Mikro mk3 on your desk, holding it up at a 20-degree angle in order to better see the LCD screen and buttons, and also making it a little more ergonomic for finger-drumming at arms-length.
The linked model designed for the mk1 version was a great start, but a minor annoyance encouraged me to edit the model a bit more. I slightly changed the gap between the front and rear cradle arms to more closely match the mk3 while leaving space for a couple 3mm EVA foam pads on each end, plus a couple mm extra wiggle room. I also lowered the height of both arms, particularly the rear arm so it doesn't obstruct the USB port when the stand is positioned directly under the device's built-in rubber feet. I also recommend gluing a couple additional foam or rubber pads on the underside of the stand to act as non-slip pads.
A pair of these will fit on the MINI printbed if they're arranged just right. I used [Polymaker Silk PLA - Silver] with PrusaSlicer's [0.25mm - DRAFT] preset and it came out great.
I've uploaded bgcode to print a pair on the MINI, my PrusaSlicer 3mf project file, my blender project file where I edited the model and cleaned up the geometry, and an STL exported from blender.
Thanks to jl_mayar for the great model to start from. Hope this remix helps someone else. Happy printing!
The author remixed this model.
Changed the gap between the front and rear cradle arms to better accommodate the slightly different dimensions of the mk3 version, while leaving room for a couple foam pads. Also lowered the height of the cradle arms, particularly for the rear arm so that it will clear the USB port when positioned directly under the device's built-in rubber feet.