Dremel MultiPro drill press stand adapter for PACE PS-90 soldering iron

I designed this 2-part adapter to enable mounting of my PACE PS-90 soldering iron to my old and now discontinued Dremel MultiPro Model 212 drill press stand I've had for decades. I am aware that this is a very specialized functional part for a tool combination that almost nobody has but… You never know, it might be useful to somebody.

The only part I did not design is the M3 screw knob. I used a part designed by David J (Thanks David J) :

https://www.printables.com/model/494255-m3-screw-knob

I used the shorter one but I'm confident both sizes should work. Here is a list of the hardware you will need for the adapter:

• 2 M3x40 SHCS's
• 2 M3 Hex Nuts (or lock nuts)
• 2 M3x5x4 Heat set inserts

When mounting the adapter to the drill press stand, first insert the iron, then insert the front part of the adapter from the bottom so it's resting against the top ring of the stand. Make sure the iron is snug inside the front part and slide in the back part of the adapter from the top. Insert and tighten the M3 screws and then tighten the drill stand ring knobs.