Ich musste bei meinen Fliegengittern die Netze austauschen, die waren nach ein paar Jahren Gebrauch löchrig und unansehnlich geworden.
Beim ersten Fliegengitter bin ich fast verzweifelt, der Keder ist da immer wieder raus gerutscht, den habe ich einfach nicht richtig rein drücken können.
Also schnell dieses Werkzeugt konstruiert und gedruck- damit ging das einsetzen des Keders super einfach.
Passend für einen Kedergummi mit ø4,5mm (oder etwas größer)
Benötigt werden noch
entweder
oder
Die beiden Stege des Griffs sollten nicht zusammengezogen werden.
----
I had to replace the nets on my fly screens as they had become holey and unsightly after a few years of use.
I almost despaired with the first fly screen, the piping kept slipping out, I just couldn't push it in properly.
So I quickly designed and printed this tool - it made inserting the piping super easy.
Suitable for a piping rubber with ø4.5mm (or slightly larger)
You will also need
either
or
The two bars of the handle should not be pulled together.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0,2mm
Infill:
25% - 80%
Filament: none PLA or better
what you want
Notes:
Die Rolle habe ich mit 60% Füllung gedruckt.
Beim Griff habe ich den Bereich der Stege und etwa 5mm dahinter mit 80% gedruckt, den Rest des Griffs mit 25%.
----
I printed the roll with 60% infill.
For the handle, I printed the area of the bars and about 5mm behind them with 80%, the rest of the handle with 25%.
Category: Hand Tools
The author marked this model as their own original creation. Imported from Thingiverse.