Holder for a kitchen roll using MultiBoard and MultiConnect for support.
The default is for 40mm rolls, which I think are standard in the UK
I printed in PLA with 0.2 mm layer height, 15% infill and 3 perimeters. Make sure to have support on for the back
The MultiBoard I am using - https://www.printables.com/model/739271-multiboard-for-original-prusa-enclosure
MultiConnect - https://www.printables.com/model/716558-multiconnect-generic-connector-for-your-board
The author remixed this model.
Remove the screw holes on the back and added in MultiConnect support