Raspberry Pi 5 NVMe case (with Pimoroni NVMe Base board)

This case was designed to house a Raspberry Pi 5, the Pimoroni NVMe Base and an optional official RPi Active Cooler.

It is a 3-part print:

• The bottom of the case
• The lid of the case
• The power button

Holes have been added in several places to aid in ventilation of both the Rpi5 and the Pimoroni NVMe Base.

The included power button clicks the power button on the RPi5 inside the box.

The lid screws neatly into the bottom part of the case using 2.3mm screws (that's what they measure at I got them from an old Flirc case I had lying around).

Note that the sdcard slot is not accessible when using this case.

Printing instructions:

• Print at 0.2mm layer height
• Printing in PETG is recommended as it has better heat resistance but PLA is probably fine as well
• Power button should be printed in clear / transparent material to allow the internal LED to shine through as seen in the images