Rear bumper diffuser for TESLA Model 3

The part labeled 1-3 is intended for printing three pieces for the center of the bumper, parts 4-5 for 2 pieces, part 6L for the far left, and part 7R for the far right (see labeled diagram).

The parts are designed to be mounted at a distance of 18-20 cm from each other. In the diagram, they are spaced 20 cm apart.

For mounting, I recommend stainless steel screws approximately 3.5x20 mm.

Printing requires no special settings and does not need supports.

When installing, ensure the correct orientation so that all parts face parallel forward.

Happy printing!