Build Plate Cleaner Holder Z-Frame Mount for Prusa i3 MK3/S/S+/MK4 (With drying rails)

A build plate cleaner holder, which can be mounted on the z-frame of your Prusa i3 MK3/S/S+ 3D printer. Maybe it's also usable on the Prusa MK4, but I'm not sure, if the z-frame has the same measurements.

I added a second version without drying rails but with a full dovetail cutout over the complete width of the holder for a flexible mounting position. The reason for this is, that you can use two filament spools on the standard filament holder when mounted centered to the z-frame. I suggest using the holder with drying rails and slightly shift the filament holder to either side.

Mounting tip:
First mount the clips on the z-frame and then slide the holder in.
 

Clip Print Settings:

Rafts:
No

Supports: 
No

Perimeter:
5 - 6

Resolution:
0.15

Infill: 
15% - 20%

Filament:
PETG


Holder Print Settings:

Rafts:
No

Supports: 
Use supports for the dovetail cutouts

Perimeter:
2

Resolution:
0.2

Infill: 
15%

Filament:
Any

Notes:
I designed the dovetails / cutouts with a 0.1 tolerance. Keep in mind, that you need to set the supports for the cutouts to that value in the settings for a snug fit with still enough wiggle room.

Added dovetail cutouts on the back of the holder for the z-frame mounting clips.

Because I needed the deapth for the cutouts, I also added some drying rails like @DarkZed1 did in his remix.