Printed using my MK3S+ with eSun PLA+ Purple filament. I added a 5v Winsinn fan. Most difficult part of this project was getting the wiring figured out. I drilled 2 holes to route (1) the wires for the PSU connection to the Pi board and (2) the fan to the PSU. I added non-slip feet to the bottom. Note that the holes for the nuts are too small for the nuts, so without the feet, the case would be resting on those nuts. The completed project weighs in at exactly 7 ounces.
Purchased the PSUs from Sager Electronics, the fans and C8 connectors from Amazon.
Thank you aeberbach for sharing this great design, and for your assistance too - greatly appreciated! (edited)
