ZEROG BED COOLING FAN MOUNT USE 12032 BLOWER

Im inpatient to wait for pei sheet cool to get it out build plate so this gonna help it cooling quicker. I add gcode for it so when it finish the print i will move bed all the way down and fan will kick on until temp reach certain degree then turn off. And because i set my temp at 50C every time for level bed every time it start the print so it help when parts failed and you can cool it down quicker and start it again quicker.

The model height is 144mm from base to top make sure if your bed can move all the way down to right where that fan at before you print it.

Notes:

This model is for 12032 blower fan have 2 hole chamfer in the back side other fan might not fit (i will include picture for this)

https://www.amazon.com/dp/B0C6D89BQJ?psc=1&ref=ppx_yo2ov_dt_b_product_details

2xm3 for the base mount

3xm4 bolt and nut for fan mount 

Print Settings

Printer:

ZERO G

Rafts: 

Doesn't Matter

Supports:

Yes

Resolution: 

0.2

Infill:

20% or more

Filament:

INLAND ABS YELLOW