this was diffidently more complicated to make. but it does look nice I hope you guys can appreciate the time I put into this stuff.
this adapter should work on a couple of tippmann markers that uses the same feedneck mounting points as the tippmann 98 does
itchute movie link: https://www.bitchute.com/video/NZlRmetBmjad/
link to the Installation video of the T15 and TMC magfed adapter
Update**_
23-05-2020 TMC MW MR V4 added there was a error in part V3. this error was not noticeable in cura. I mean I have printed them with out a problems like 7 times. but I'm now a better skilled in freecad so it was a easy fix
update 23 06 2020___**
new mag release button wide added.
DMAG Bren LMG
https://www.thingiverse.com/thing:3937441
DMAG FG 42, P90 (Right)
https://www.thingiverse.com/thing:3937500
DMAG P90 (centered)
https://www.thingiverse.com/thing:3937473
DMAG FG 42, P90 (Right)
https://www.thingiverse.com/thing:3937457
DMAG Tall High
https://www.thingiverse.com/thing:3937511
DMAG Tall Low
https://www.thingiverse.com/thing:3937523
DMAG TIP98 normal
https://www.thingiverse.com/thing:4115746
DMAG TIP98 side
https://www.thingiverse.com/thing:4188333
DMAG TIP98 down
https://www.thingiverse.com/thing:4190624
DMAG cyclone side
https://www.thingiverse.com/thing:4227717
DMAG cyclone up
https://www.thingiverse.com/thing:4227722
DMAG cyclone down
https://www.thingiverse.com/thing:4227712
TMC Bren LMG
https://www.thingiverse.com/thing:3790969
TMC FG 42, P90 (Left)
https://www.thingiverse.com/thing:3919897
TMC FG 42, P90 (Right)
https://www.thingiverse.com/thing:3918514
TMC P90 (centered)
https://www.thingiverse.com/thing:3925118
TMC Tall high
https://www.thingiverse.com/thing:3925141
TMC Tall Low
https://www.thingiverse.com/thing:3925181
TMC TIP98 normal
https://www.thingiverse.com/thing:4112853
TMC TIP98 SIDE
https://www.thingiverse.com/thing:4188772
TMC TIP98 down
https://www.thingiverse.com/thing:4188787
TMC cyclone SIDE
https://www.thingiverse.com/thing:4224827
TMC cyclone down
https://www.thingiverse.com/thing:4226365
TMC cyclone up
https://www.thingiverse.com/thing:4226396
Supports:
Yes
it can be a smart thing to melt in a iron or copper wire in the part shown in the picture. or print that section with a higher infill. at first was I surprised that it looked that is was not needed. but I had a failure on my second print so. keep that weak spot in mind.
for use of the 2 pins, just use 2x m3 bolts with a length of 12mm.
and of course 1 spring and 2 pins are needed to make the mag catch work.
The author marked this model as their own original creation. Imported from Thingiverse.