Mit quite spectacular, but sooo handy :)
Reset button for MMU2 and MMU3
Here is the part that is missing from the MMU2 & MM3 kits.
The thing often referred to as "the button" in the manual.
In the contest Quick and Useful Prints
147
718
44
2752
updated August 19, 2023
Makes
Comments
@Papyjo Merci.
@dteng_185446 Thanks.
Added that for my new MMU3 and from my point of view it is great addition. Easy to use and it is fixed in place. Thank you! :-)
@Krosta I'm glad you like it. :) Thanks.
@iggyt_108578 Thank you.
@RCNet are you satisfied with it? You will get better results if you print 3 of them at once. That way your print cools down between layers.
@KmanSweden thanks for the follow up. It printed fine as a single, but I ultimately went with the snap-in remix instead. You might want to consider a little longer version as well. It looks like others had better luck, but with my combination of control board and R4 of the MMU3 cover, it ended up slightly recessed. (edited)
This is an small part but very interesting to have a nice button for Reset the unit. Easy to print and install. It's a must if you have an MMU2 or MMU3 unit.
Printed with Prusament PTEG with default settings for this material. No supports or brim required. Thanks for share! (edited)
Thanks!
@Joker looks great.
Works great on mmu3 best simple upgrade thanks alot ps I had to print 5 for them to print properly so they had time to cool many thanks (edited)
@Hello_474427 Nice. Thanks for sharing.