Arduino Giga Display Case + stand (minimalist design)

This model has only been tested with PLA.
2
36
0
467
updated May 9, 2024

Description

PDF

This is a simple case made for the Arduino Giga display. The base attaches to the case via an M4x20mm bolt and an M4 nut. The actual Giga display is attached to the case via 4 m2x5mm (can use 10mm). Note that you must use washers on each screw to ensure the case is properly held in place by the screws. 

There are two versions of the base, a flat version and an angled version.

Tags



Model origin

The author marked this model as their own original creation.

License