Kingston Memory Card Reader Monitor or Table Mount

Table or Monitor mount for a Kingston Memory Card Reader. You will need a couple of M2.5 screws to put the backplate on with and an M5 screw for the mounting clamp. The Clamp has an M5 hole in it and the Mount Screw Cap is threaded for M5. Print the main housing flat on the bed with supports everywhere, I used 0.2mm support Z distance and 10% support density in Cura. The main housing may warp if it seperates from the support material so you might have to play around if your using a different slicer or whatever.

Update 28/01/2018 - Added new backplate with cable strain relief.

Print Settings

Printer:

Anet A6

Rafts:

No

Yes

Resolution:

0.1

25%

Notes:

Supports everywhere, 0.2mm support Z distance, 10% support density for Cura