Finger splint

Worked well. Had to make it bigger around and a little shorter for a thumb but worked well.

I orientated the model vertically and enabled supports just for the bottom edges. Printed quickly (25min) on the Bambu X1C. I printed a second one scaled down to 80% as it's for my 11yo son.

Amazing you have this available within a half hour so we didn't have to wait for shipping.

Had to shorten it a little for my wife’s finger but it is serving her well. Thanks!

My wife cut the end of her finger and needed something to protect it. I added detachable support so that it prints upright. The support snaps off - I'll add it as a remix

It's a great model. However it is a little small if you have an injury that swells the finger.

Printed it a bit larger. 117%. Nice model thanks!

Added supports just on the edge of the overhang and it printed great. Good if you cut your fingers a lot like me.

Hi Cipy, it is perfect idea. Unfortunately it is very difficult to remove support from printed model. So I make small modification there. I added thin rounded part which can be easily breaked off.