Extremely inexpensive stringing test
Extremely inexpensive and fast to print stringing test!
3
41
3
157
updated May 7, 2024
Description
PDFThis is a very simple, inexpensive, and fast-to-print stringing test.
It takes 3-4 minutes to print with a printing speed of 70 mm/s and a travel speed of 175 mm/s.
The gab is about 3 cm wide.
As a bonus, here are my retraction settings in PrusaSlicer for my Anycubic Kobra 2 with ESUN PLA+:
| Printing temperature | 207 C° |
| -- | -- |
| Use ramping lift | yes |
| Maximum ramping lift | 0.9 mm |
| Ramping slope angle | 1° |
| -- | -- |
| Retraction length | 2.5 mm |
| Retraction Speed | 65 mm/s |
| Retract on layer change | yes |
| Wipe while retracting | yes |
| Retract amount before wipe | 70% |
I found out that at the end the "Ramping slope angle" helped with stringing the most (try to keep it low), besides the nozzle temperature of course.
Tags
Model origin
The author marked this model as their own original creation.
