Cascade Card Wallet Remix with Drawer

I really liked the original version of this wallet and printed it out a few weeks ago but I found that I really only needed 5 cards and I needed a place to store my Tile tracker card so I added a drawer on the back.

Some other modifications is 
- Making it print in multiple parts to allow for different colors on the sliding mechanism
- Tightening up the tolerances to hold the cards tighter and help the fan out mechanism 
- Removing the texture on the slider since it tended not to print out that great and I have a textured bed surface, so I found that worked better and looked nicer

Version 1.1
- Thickened up some of the walls to make it easier for 0.6 printers to print and prevent an issue during printing where some wallets fell apart after printing
- Toughened up the spring to prevent snapping and provide a more satisfying click (should also help the slide out mechanism be a little more reliable)

Experimental
- Added a new hinge version, this has some really tight tolerance so crank down your layer height.
- You can also try printing it with the door side down which works better for the hinge but causes the other parts to sag without support

Tighten up a lot of the tolerances
Reduce the amount of cards to 5
Add a drawer on the back
Change the card holding mechanism as the current one tends to pull the cards together