Bed Adhesion / Warping Test

Struggled a lot with warping with one specific filament brand out of nowhere, this model helped a lot although this issue did not disappear completely. Thanks for sharing!

Looks fine, but it warped a bit and pulled up the magnetic plate.

I tested it with PETG and could not see any warping.

We have tested a new ABS material.
With Prusa Enclosur. (edited)

We have tested a new ABS material.
Without Prusa Enclosur. (edited)

Good model to test ASA on an open bed slinger ;)
Needed 110°C bed temperature to make it work.

A good torture test but not wide enough to test the effect infill has on warping.

A really hard test for warping. I use it a lot for trying out settings before ASA-prints.