Monitor 3x5 Card Holder

I've been trying to organize my desk and previously made a pen cup that hangs off the back of my monitor, you can see two of them in the picture. It is available here: https://www.thingiverse.com/thing:4194714

I use a 3x5 card each day to list out my tasks and they have also been getting either misplaced or in the way. So here is the next monitor storage device, a 3x5 card holder that hangs over the back of my monitor.

It can be printed without support if you print it upside down. I made the inside of the base with a large incline to make it easy to grab the nearest card and avoid needing to print with support. I like to print these at a fairly high infill (50%) to keep the arm from being fragile.

3/6/20 Fixed a problem in the file where the incline was slightly outside the cup causing some ugly lines. Should be fine now.

Print Settings

Printer:

QIDI X-One2

Rafts:

No

No

Resolution:

0.2 mm

50%

Filament: Shengtian PLA Plus Purple Silk