Dragon Phone Holder

WARNING POINTY

//////////////////////////////////////Version 2 6/25/24\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\

      I made it flat to the ground  so it doesn’t get so stringy and weird at the bottom.  You will no longer need a draft or supports unless you want them for the horns on the top.

/////////////////////////////////////////////version 1\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\

  Should fit phones and tablets.

     The phone holder part is 1 inch wide or 2.54 centimeters. It is about 3.40 inches long or 8.636 centimeters long.

     This probably won't need supports I used none and the tail jus but that was it.  I used silk PLA. 

     I also use a Creality Ender 3 v2 Neo.