flask with polygons

flask with polygons

update · added STLs

design inspired by traditional clay honey containers from the south of Portugal

photo shows print with:

• 0.16mm layer height
• 15% gyroid infill
• no brim or supports

printing in 0.16 instead of 0.20 increases print time by around 30 minutes, but in my opinion is worth it for the finer details in pattern and enhanced quality in the screw thread

If you enjoy using this 3D model and are able to, please consider supporting my work by buying me a coffee. Your contribution goes a long way in fueling future creations. Thank you for being a supporter!

note: all photos uploaded are of the actual printed model, taken inside a lightbox or in natural light on top of a desk / table