LED BOX - Illuminated Display Base

Jellyfish model used in the pictures created by Toxværd

• ESP8266 Node MCU v3
• 6mm square button
• Individually adressable LED strip ~+ 30cm
• 4 M3 brass inserts
• 4 M3 screws (max 12mm length)
• 4 M2.5 brass inserts
• 4 M2.5 screws

warning :  print orientation not set in the files, always print face down, no supports required 

• Main & Diffuser : Print as one if you have an MMU / AMS
• Bottom
• Cache
• Crane (optional)
• Button cap

I printed everything on a Bambulab X1C with 4 walls & 15% infill.
Filaments used are : PLA Galaxy Nebulae & PLA Basic White from Bambulab

• Heat inserts 4x M2.5 on the bottom standoffs & 4xM3 in the main holes
• Solder the Led strip & button to the ESP8266
• Attach the led strip around the rim
• Use the cache in between the led strip & the bottom
• Put the button into the specified grove & glue the button cap on the other side
• Optional : Attach the crane to both part

Any problems with assembly? Don't hesitate to reach out and I will try my best to help you and improve this guide :-)