iFi Zen Amp & DAC Under Desk Mount

An Under-Desk Mount for an iFi DAC & AMP Combination. Can be attached with VHB Tape or 6x M3 Countersunk Screws.
6
64
0
333
updated April 15, 2024

Description

PDF

I wanted to mount my iFi ZEN DAC & Amplifier underneath my desk, and nothing available would do the trick! This mount fits reasonably snugly to the DAC & AMP, with the DAC on Top and the AMP below.

While the bottom is open, I have never had any issue with the Amp falling out, but I definitely recommend printing this in PLA, ABS, or PC over PETG (I did all four while testing and refining the fit & finish). While PETG holds the AMP & DAC just fine, the amount of give from the PETG's flexibility made me a little nervous.

Settings for the Mount in the Image:

  • Printer: BambuLabs X1C
  • Preset: 0.20mm Strength
  • Material: Polycarbonate Black (Though ASA, ABS, and PLA have all worked fine too)

Advice for Printing:

  • Print the Mount laying on it's back, (where the cables will attach to the DAC/AMP) rather than on the large flat part. Your Slicer will recommend the opposite, but you want the layer lines going from top to bottom to have the most strength in the direction of gravity.

You are welcome to use & remix this mount however you like, I just ask that you attribute me, or link to this page & model.

The Original Onshape Design Link

Tags



Model origin

The author marked this model as their own original creation.

License